All threaded holes in the block and cylinder head should cleaned and tapped with a thread chaser. All bolts being installed should be lubed with a light oil or anti-seize on the bolt threads before assembly.

Place the three counter sunk bolts through the front plate. Install the three "B" spacers, then the back plate, and finally the "A" spacers. Holding all the pieces toghether align the bolts and hand thread into the driver's cylinder head.

Next install the power steering pump reservoir (DD-SR-PS-RES) onto the 1998-02 Camaro Power steering pump.

Install the power steering pump onto the front bracket using the included 8mm bolts with stainless washer.

 Install the alternator between the two brackets using the lon socked head allen bolts with a stainless washer under the head and nut.

Install the billet small diameter power steering pulley using the proper install tool and the idler pulley. Torque bolts to 28 ft lbs.

Belt routing is as shown.

Belt sizes-

Small case alternator Gates K060750

Large case alternator Gates K060755

When using 2010-15 Camaro water pump and tensioner add 4.0" to belt length.